Production
A full cycle on one site: from birch log to packed bundle. Automated lines and instrumented control at every stage.
Four production stages
Every stage is checked for parameters — moisture, thickness, bundle geometry.
- 01
Veneer peeling
Logs are debarked and cut, then an automated rotary lathe peels veneer of the required thickness. Raw material is locally harvested birch.
- 02
Drying
Veneer is dried on a high-speed line; residual moisture is controlled per bundle before lay-up.
- 03
Lay-up and glue application
An automated lay-up line grades veneer, performs edge gluing and doses glue per layer.
- 04
Pressing and calibration
The bundle goes to cold and hot presses, then format trimming, sanding and packing of finished panels.
Hot-press shop: presses and veneer packsLines and units
The equipment set covers all stages inside the mill — no semi-finished product leaves the site, so lead times and quality do not depend on subcontractors.
- Automated rotary lathe
- High-speed dryer line
- Automated bundle lay-up line
- Cold and hot presses, calibration and format trimming
- Industrial heat supply system for the workshop

How we control a batch
Control is built into the process rather than sampled at the end.
Incoming raw material
Log acceptance: species, diameter, moisture, no rot or mechanical damage.
Veneer control
Thickness, moisture and grade of every bundle before lay-up.
Pressing control
Temperature and pressure by schedule, press dwell time, geometry of the finished sheet.
Acceptance testing
Batches are tested in an accredited laboratory: glue line strength, bending, formaldehyde.
Need prices and samples?
We will send a commercial offer, thickness chart and document copies as soon as possible.